Crestron Touch Panel Instructions

Powering Up the Equipment

The equipment is controlled using a Crestron Touch Panel interface.

If the touch panel's screen appears to be off, touch the screen to wake the display. When awake, press the Press to Begin button.

If the classroom has Crestron AirMedia displays, see documentation for AirMedia.

You will now see the Crestron Touch Panel home screen where you select a video and audio source. The projector will power on once you select a source to display.

Enable Plasma Displays

  • Select the Advanced Display Mode button
  • Select the source Computer
  • Select the destination in the Send to menu
  • Select Projector
  • Select Monitor
  • Select Audio

Special Feature

Johnston Hall, Room 107 has the capability of displaying different sources on the projector and plasma displays.

The podium computer can be displayed on the projector while a laptop can be displayed on the plasma displays.

  • Select the Advanced Display Mode button
  • Select the source Computer
  • Select the destination in the Send to menu
  • Select Projector
  • Select Audio
  • If you want to display a different source, select a new source Laptop
  • Select the destination in the Send to menu
  • Select Monitor

Please Note:
The plasma displays will only display resolutions 720 lines or less. Set the laptop display output to 1280x720 at 60 Hz. If you select 1280x800, it will not work.



Volume Control

Volume controls are in the Crestron Touch Panel.

NOTE: The podium computer and a laptop have separate volume controls within their operating systems.

Powering Down the Equipment

Be sure to remove any media from the equipment before powering it down. When you are done using the equipment, exit any screens in the Crestron Touch Panel until you see the Shut Down button. Select it then select System Off in the subsequent screen.

The computer's power state will not be affected. Remember to log out of the computer.

Back to Johnston Hall Classroom Technology